Beiträge von etrock

Zitat von influenist

Hi @etrock you want to use some isolation on those cables you soldered onto the board. Otherwise you could short circuit the board.

Did you use the m2 module from Taobao? https://item.taobao.com/item.h…e5-496b-8eac-41be004559df

No more slots，i added a nvme ssd....

943602CS`s WIFI work fine at xiaomi notebook, but Bluetooth need jump wire for USB, xiaomi's nvme solts no usb connections.

Zitat von influenist

Many thanks for your input!

Option 1, you couldnt use both the webcam and the wifi module?

Could you provide a picture of your results on option 3 ?

Option1==> I broke the solder pad, so my this port, game over.

Option3,

add a USB-HUB ,then usb wifi put inside.

Used the gray antenna(Minor antenna) connect to usb wifi.

Leave the main antenna(black) for Win10 used.(intel wifi 5G 877Mbps will down to 433Mbps,and BT will no signal at Win10~)

After this?, usb wifi ?signal work fine when put on the back cover?.??

usb-hub

https://item.taobao.com/item.h…abaDSFITN&id=574744995214

Hi friend, have you solved the multi-finger touch control?

i used VoodooI2C.kext，still only one finger work , whether interrupt or polling mode.

In system setting can't find touchpad device.

Here is the USB port.

null、d+(d-)、d-(d+)...... up to down at this connecter.

i add a usb wifi(RTL8188) here, work fine. but abandon webcam.

so i want to add a usb-hub, but broke the PCB pads, very very bad luck

so i find the second usb, it work, but usb type-c（the power plug） need always plug in！

finally, i used here add the usb hub.....remove inductance and lead wire.

http://www.miui.com/thread-10556125-1-1.html

USB from Type-C, there are two groups.